Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
settings in esa for jake switch with swaped cumming x15
#2
You need to set your multiplexing settings on engine ECM to point to the cab controller.
You can find these settings in INSITE > Features and Parameters > Multiplexing.

49 is correct, make sure that the correct CAN channels & baud rates are set.
Newer ECM's use CAN4 while older ones do not. The baud rate is also set different.

There are also parameters set in the calibration that are specific to J1939 communication. 
Each calibration likely has different ones set for different chassis.
If I helped in any way, please give THANKS + REP!

Cummins INSITE 8.x+Fleet Cals, Password Resets
Cummins Calterm 5.14.0
Calterm Master Tool Ultimate v10.3
Cummins INCAL Tool v8.5
CNH 9.2 Dealer or Engineering
Wabco 13.6 Engineering
DDDL 8.20 - Levels 10/10/10
CAT ET 2024A + Perkins 2024A + FPKG/AutoGen
SR 4.12 Engineering
Bendix ACOM Pro 2024
Allison DOC 2024
JPRO 2024
Remote Tuning for all Cummins engines. PM for Quote.
  


Messages In This Thread
RE: settings in esa for jake switch with swaped cumming x15 - by zyNoT - 11-03-2024, 01:45 PM

Forum Jump:


Users browsing this thread:
1 Guest(s)