[manne88]

Hi all,

Here you will find the CAT ET2017A KG.
I'm giving for FREE.

Instructions:
1: Install ET2017A (right click on file run as administrator) then right click on the icon of et2017A, properties, compatibilty, check run as administrator

2: Copy from downloaded file comet.exe and cometdll.DLL in folder c:\program file(x86)\common files\Offboard Information Products\2017A\Comet
3: Copy from downloaded file FlashServer.dll and cometdll.DLL in folder c:\program file(x86)\common files\Offboard Information Products\2017A\Flash
>>> In the downloaded folder there are 2 subfolders: FILES and CRACK, which contain the same 3 files. Which ones are the right ones?

4: Create folder c:\FlexLM
5: Run as administrator keygen copy the code
6: Run keygen4keygen and paste the code then CALC copy the answer in keygen and click ok, than close keygen4keygen
7: From command prompt (or if you want use networksisid) type: ipconfig/all and copy the mac address of ethernet card (xx-xx-xx-xx-xx-xx)

8: Run et2017a copy the code and past in the keygen (Request code), past the mac address in Host ID in keygen
>>> Which code should be copied and where?

9: Click on generate and copy license.dat in folder c:\FlexLM and copy the answer code from keygen in the small prompt of the et2017a
>>> I don't see any prompt in et2017a, where is it?

10: Go in winflash and past the same answer code for activate winflash too.
>>> If I open winflash, there is no place where to paste anything. Where should I do it?


Please give THANKS and REP!

Hey Zezima, thanks for posting this.


I have a few questions regarding your instructions. I run Win 10 64bit if it's of any help and I have added the environment variable.
If you could do screenshot for the whole procedure, it would help a lot. Thanks!