ZEZ AUTO > Heavy Vehicles > Heavy Vehicle Tuning > Need ECM image or template for kw900L c
ZEZ AUTO > Heavy Vehicles > Heavy Vehicle Tuning > Need ECM image or template for kw900L c

Thread Rating:
  • 1 Vote(s) - 3 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Need ECM image or template for kw900L c
burrows_03 Offline
V.I.P
******
Posts: 112
Threads: 22
Thanks Received: 186 in 52 posts
Thanks Given: 73
Joined: Dec 2017
Reputation: 73
ZEZ: 219.75 ZEZ [Buy]
#7
01-10-2018, 11:12 PM (This post was last modified: 01-10-2018, 11:19 PM by burrows_03.)
Insite has multiplexing parameters and switch addressing that can be done it might be that the cab controller software needs to be updated. Then configured make sure all the features you are needing are enabled there to. Either one could cause you the issue
The source address cab controller 49 is in insite multiplexing address
[-] The following 4 users say Thank You to burrows_03 for this post:
  • alicestar, cumapart, DieselTaz, jXfusion
Reply
  


Messages In This Thread
RE: Need ECM image or template for kw900L c - by burrows_03 - 01-10-2018, 11:12 PM

Forum Jump:


Users browsing this thread:
11 Guest(s)