[Lucifer]

Hey Doing an engine swap, cat is shut, got a used Isx15 cm2250 from a wreaker cpl3606, where could a guy get an ECM image or template so the jakes, fan overide, cruise and ideal speed work, I know it’s a shot in the dark but it probably is doable

Since everyone has theirs setup differently I would recommend you start fresh. Go into features & parameters in INSITE and configure each setting to your liking after a flash. 

Another option would be to open the XML version of the template and change the info to match the new engine, then use INSITE to apply the new template. Problem with this though is that not all engines have the same parameters names. You could very well experience some conflicts. I’d recommend starting fresh. iNCAL defaults have some of those features you mentioned disabled by default, just enabling them and configuring them would fix your problems.