[zyNoT]

Dear ZyNot,

It means that I should use Calterm 3.17 ot Calterm 4.3.1

Another version is not stable.

Is it correct? 

Sorry. I am new and don't have much experience.

Thanks in advance

Use 3.17.0. 
Dataplate info is read-only and cannot be programmed on newer Calterm but for good reason.
If you change data plate manually while connected to live engine you will offset the calibration software phase. 
This will cause engine to shutdown after a certain number of key-offs. 

If you really need to use newest Calterm and need to program data plate then you need to put ECM/Calterm into super user mode, this will allow read only parameters to be programmed.