Thread Rating:
  • 1 Vote(s) - 3 Average
  • 1
  • 2
  • 3
  • 4
  • 5
fault blocking with calterm
#5
I second what Marajin said. Don’t go blocking codes, you’re going to end up with a broken engine a year or less down the road. Do it right or don’t do it at all. First off, start from a scratch INCAL file - anything this other “tuner” did is obviously incorrect so you might as well start from scratch with the support of someone who knows how to do it right. I recommend you get ahold of Marajin and get it done right.
If I helped in any way, please give THANKS + REP!

Cummins INSITE 8.x/9.x+Fleet Cals, Password Resets
Cummins Calterm 5.16.0
Calterm Master Tool Ultimate v10.3
Cummins INCAL Tool v8.5
CNH 9.2 Dealer or Engineering
Wabco 13.6 Engineering
DDDL 8.20 - Levels 10/10/10
CAT ET 2024A + Perkins 2024A + FPKG/AutoGen
SR 4.12 Engineering
Bendix ACOM Pro 2024
Allison DOC 2024
JPRO 2024
Remote Tuning for all Cummins engines. PM for Quote.
[-] The following 4 users say Thank You to zyNoT for this post:
  • Meat-Head, sjw1987, sp33d, technik9195
  


Messages In This Thread
fault blocking with calterm - by sjw1987 - 12-13-2018, 07:56 AM
RE: fault blocking with calterm - by zyNoT - 12-16-2018, 04:21 PM
RE: fault blocking with calterm - by sjw1987 - 12-18-2018, 04:43 PM
RE: fault blocking with calterm - by fazooley - 12-20-2018, 03:24 PM
RE: fault blocking with calterm - by zyNoT - 12-20-2018, 06:37 PM
RE: fault blocking with calterm - by Zezima - 01-31-2019, 09:47 PM

Forum Jump:


Users browsing this thread:
3 Guest(s)