+- ZEZ AUTO (https://www.zezauto.com)
+-- Forum: Heavy Vehicles (https://www.zezauto.com/Forum-Heavy-Vehicles)
+--- Forum: Heavy Vehicle Tuning (https://www.zezauto.com/Forum-Heavy-Vehicle-Tuning)
+--- Thread: MBE programming question (/Thread-MBE-programming-question)
Pages:
1
2
RE: MBE programming question - ISXCUMMINSGUY - 05-03-2018
can you make changes as far as turning things on and off or set input settings
RE: MBE programming question - kamiar - 05-03-2018
Just install DDDL8.06 or 07 and it installs and activates with DDDL8 and works perfect, but as for coolant level, i dont think you can change that with mbe reprog tool....
RE: MBE programming question - ISXCUMMINSGUY - 05-03-2018
do you know if anything or anyone can block the code. Can not find problem all wiring good. Maybe something in cab controller and have no way of looking at it
RE: MBE programming question - Lucifer - 05-04-2018
(05-03-2018, 06:03 PM)ISXCUMMINSGUY Wrote: do you know if anything or anyone can block the code. Can not find problem all wiring good. Maybe something in cab controller and have no way of looking at it
I thought the cab controller controlled those sensors on the older models.
RE: MBE programming question - ISXCUMMINSGUY - 05-07-2018
yes but then it sends a signal to the ECM... The ECM is not receiving signal from cab controller. All wiring is ok. So either cab controller messing up or ecm...When you unplug it it does change to open circuit .. the code is for low coolant. Installed new sensor still same. Customer had to use truck so we let it go for now will have it in here another weekend and see what we can do....
RE: MBE programming question - Lucifer - 05-07-2018
(05-07-2018, 09:39 AM)ISXCUMMINSGUY Wrote: yes but then it sends a signal to the ECM... The ECM is not receiving signal from cab controller. All wiring is ok. So either cab controller messing up or ecm...When you unplug it it does change to open circuit .. the code is for low coolant. Installed new sensor still same. Customer had to use truck so we let it go for now will have it in here another weekend and see what we can do....
If fault changes then it's relaying data and power. What type of sensor is installed? Is it installed upside down?
RE: MBE programming question - ISXCUMMINSGUY - 05-09-2018
Its a coolant level sensor that screws in. With a 2 wire plug.... Ground one side and volts on other side.
RE: MBE programming question - Lucifer - 05-09-2018
(05-09-2018, 10:19 AM)ISXCUMMINSGUY Wrote: Its a coolant level sensor that screws in. With a 2 wire plug.... Ground one side and volts on other side.
Hmmmmmm. I’m trying to see how SAE fault of low coolant would show when it’s receiving data and power. This is a first I’ve heard of it. Usually a bad sensor would cause it but you said you replaced it already.
RE: MBE programming question - Rocinante - 05-15-2018
OP, did you ever get this solved?
RE: MBE programming question - ISXCUMMINSGUY - 05-16-2018
never did...