[zyNoT]

...

Also if you are flashing ANY CM2350 module, you cannot use INSITE 7.6.x it is too old and you will end up with corruption of engine control code.

...

 All a person has to have is the SP5 patch for 7.6 and it is fully compatible for flashing all CM2350's that are pre-X15 engine model era.

Incorrect. Not only have most of the BDR’s moved over to 9.40.16 phase, but even the older 9.40.13 phase cannot be properly flashed with INSITE 7.6 even with SP5 (7.6.2.240 SP5). I have done extensive testing and even when all parameters look good, all the tables addresses and RLOC addresses have shifted leaving the calibration and engine control code subfile in a corrupted state. Usually you will see a fuel fault code and 2-3 other ones saying shorted to high source. You will see that even after flashing template back, you will see that it does not solve this problem and random fault codes will show up even if added to CAGT block table. 

7.6.2.240 SP5 is too old for any CM2350 especially when using newer assembly matrix.

There is nothing special about the flashing process in INSITE, it is exactly the same as Calterm except the configs are built into a Tool MSNR database. You are essentially using an ecfg from 2003 to flash a cal with a phase made in 2015 with new parameters and addresses that 7.6 INSITE doesn’t even know exist as it was created before they existed. Just trying to save others future problems, but hey if y’all want to blow up some engines then keep using INSITE 7.6.