[zyNoT]

8.10.x.x BDR? That is a very very old phase. How old of a cal are you using?

Also if you are flashing ANY CM2350 module, you cannot use INSITE 7.6.x it is too old and you will end up with corruption of engine control code. That is the equivalent of flashing a newer phase cal with an older ecfg, but erasing the default calibration and flashing a corrupted offset version in its place. INSITE uses a database to read and flash these cals, it uses internal encrypted ecfgs in the form of cummins PCL format, therefor you need an INSITE version new enough to work with these cals. 

I agree with the comments above. If you want to really learn this stuff only test on your own equipment, and you need to realize that you will need to set many days/months of dedicated time to learning how these engines / ECMs work. Some background in engineering would be a good start before even thinking about jumping into this. When reading some of the above conversation you have a lot to learn, not a bad thing but you don't want to destroy your equipment or especially anyone else's while learning.